AC Unit Replacement
Expert AC Replacement in Conroe TX

Our Services
Your Comfort,
Just Easier
832-888-2901
When The Old System Gives Out
A system that quits in August turns a repair call into a question about an AC replacement in Conroe TX. By then the question feels simple: which unit, and how soon. The harder part is everything the unit connects to. There’s a slab under it and copper that carries refrigerant into the attic. A drain has to empty somewhere, and a sheet metal box has to meet the ducts. Each of those pieces decides whether the new system performs the way its label says it will.
Mountain Top HVAC-R has worked around Conroe since 2018, and Ivan Mendoza has been in HVAC since 2011. If an AC repair still makes sense, we’ll tell you so. When it doesn’t, this page walks through the job itself, in the order we do it. The bigger buying questions, like repair versus replace, live on our air conditioning contractor page.
Load Calculation Before Equipment Selection
The first visit is a measuring visit, and nothing gets ordered until it’s done. We run a Manual J load calculation on the house as it stands today. We walk every room, measure the glass, and climb into the attic to look at the insulation and the duct runs. We also check where the air handler sits, what the electrical panel can carry, and where an outdoor unit can go. What comes out of that visit is the tonnage sizing for your house, and the equipment gets chosen to fit it.
The equipment conversation starts after that. A single stage unit, a two stage compressor and a fully variable system each have a place, and the load number narrows the field. A variable speed blower matters as much as the outdoor unit, because it sets how gently air moves across the coil. Every current model also carries a SEER2 rating, the efficiency figure printed on its label. We’re a Carrier authorized dealer, and we install Bryant as well.
What Gets Replaced Besides The Box
The outdoor unit is the part everybody sees, and it’s only one piece of the swap. A new condenser tied to an old coil, a sunken pad and a tired drain is a new system in name only.
The line set is the pair of copper lines running between the condenser and the indoor coil. When it’s the right size and in good shape, a line set flush clears out old oil and debris. When it’s kinked, undersized or sealed inside a wall, it gets replaced. Outside, the unit goes on a new pad and disconnect, so it sits level and there’s a working shutoff within reach.
Inside, the coil gets an emergency drain pan under it and a float switch that shuts the system off if water backs up. The plenum transition is the sheet metal that joins the coil to the supply duct, and it has to be built to the new coil’s footprint. Where the ducts can’t carry the new airflow, duct modification at the plenum or the returns goes into the scope. Bigger duct problems become their own conversation about [ductwork replacement](-> Ductwork Replacement and Repair).
Refrigerant conversion is the piece that catches people off guard. Under an EPA rule, new split air conditioners made since January 1, 2025 must use a refrigerant with a global warming potential under 700. Older R-410A units built before that date can still be installed while the supply lasts. Manufacturers match the indoor coil to the refrigerant, so moving to the newer one means a new coil as well.
Where First Changeouts Are Landing
Conroe’s housing stock is young, and 19.9% of it went up in the 2000s. That whole group is reaching its first replacement now. Those systems are the originals, first generation R-410A equipment installed to builder spec, and that puts the refrigerant conversion question on the table. On a first changeout the pad, line set and drain pan are as old as the condenser, since they all went in with the house. They get judged on the same visit.
Replacement Day, In Order
Install day follows the same sequence every time. Drop cloths go down along the path to the air handler before the tools come in. The old refrigerant is recovered into a tank first, because releasing it into the air breaks federal rules. Before any new refrigerant goes in, the system is pressure tested and pulled into a deep vacuum to boil off moisture.
The checks at the end are the part that proves the install. We read superheat or subcooling against the manufacturer’s chart, measure the temperature drop across the coil and take static pressure in the duct. Haul away and disposal are part of the job too, and so is picking up every scrap of trash on the way out.
“Ivan was very nice and transparent with the estimate. He completed the job in a short time and with quality. He also gave me a lot of information on how manage my a/c system replacement in the future.”
Permits, Inspection And Warranty Registration
Permit and inspection are part of the job we quote, and the permit path depends on the address. Porter is unincorporated, so the permit runs through Montgomery County instead of a city hall. Porter’s newer master planned communities also carry equipment screening and approval rules, while the older rural tracts beside them have none.
The lake communities around Montgomery add a step of their own. At Walden, the property owners association’s architectural control governs where a condenser can sit and how it’s screened. That approval lands between the signed quote and the install date. We build it into the schedule instead of promising a day we can’t keep.
Equipment registration is the last piece of paperwork, and it’s the one that costs people later. Carrier’s registered limited warranty lets the owner choose a ten year parts warranty on eligible equipment when the system is registered within 90 days of installation. Miss that window and Carrier’s parts coverage drops to five years. Bryant’s standard parts limited warranty follows the same pattern, ten years when registered within 90 days and five without. As a Carrier authorized dealer, we can register new Carrier and Bryant systems for you. Those are the manufacturers’ terms, and we check the current ones for your model at the quote.
Financing And Getting On The Schedule
Financing options are offered on system replacements. Bring them up on the measuring visit, before you’ve settled on equipment, so the payment and the equipment get weighed together. Once the new system is running, an AC tune up each spring shows whether its numbers have drifted.
Call Mountain Top at 832-888-2901 or send the form, and we’ll set up the load calculation visit. We’re open Monday through Friday 8 to 7 and Saturday 8 to noon. Our work carries a satisfaction guarantee.
Did you know?
The first American home said to be air conditioned top to bottom was a 38,000 square foot Minneapolis mansion, started in 1913. Its owner died at 37 and didn’t live to see it finished, and the house was torn down in 1933.
AC Replacement in Conroe TX FAQs
These are the questions people ask once they’ve decided to replace and want to know how the job goes.
Keep three things together. The first is the load calculation report, which shows the tonnage the house needs and why. The second is the permit and inspection record for the job. The third is the manufacturer’s registration confirmation, since Carrier and Bryant tie the ten year parts term to registration within 90 days.
The best time is before it fails, when you can choose equipment on your schedule instead of the weather’s. Muggy season here runs mid April to late October, so a spring or fall changeout keeps the house from sitting warm while you decide. A system that dies in July still gets replaced, with less room to compare options. If yours is old and limping, spring is a good window to get it measured.
Not automatically. If the other system is just as old and already needs repairs, replacing both can spare you a second round of permits, disposal and scheduling. If it’s younger or running well, keep it and maintain it. We’ll look at both on the same visit and tell you what we’d do in your house.
Yes, if it’s compatible with the new equipment’s wiring and staging. A single stage thermostat can’t run a two stage or variable system to its full ability, though. Carrier Infinity and Bryant Evolution systems pair with their own brand’s communicating controls. We also install Ecobee and Honeywell thermostats when one of those suits the system better.
Someone should be there at the start to let the crew in and point out the air handler, and again at the end for the walkthrough. In between, you don’t need to stand over anyone. Power to the system is off during the swap, so the house won’t cool until the new equipment is running. Pets do better kept away from the open attic and the propped doors.
It should, when the old system is original to the house and the new one is sized to a load calculation. A higher SEER2 rating uses less power for the same cooling, and a right sized system runs the way it was designed to. Leaky ducts can eat into those gains, so we check them first. We’d rather show you the measurements than quote a savings figure we can’t back up.
Call us. Our work carries a satisfaction guarantee, and the equipment carries the manufacturer’s registered limited warranty on parts. We’ll tell you plainly which one covers what we find.
Yes. We replace whatever’s in the house now, whoever put it in, and we recover its refrigerant before anything gets disconnected. The old installer’s choices get checked on the measuring visit, including the tonnage, the line set and the drain. Once we’ve installed the new system, the work is ours to stand behind.
Mountain Top HVAC-R | 39 Orchid Grove Pl, Conroe, TX 77385, United States | License: TACLA85135C
Copyright © 2026. All rights reserved.

